--Mobile no tune Solid State Amplifier --
uses four rugged 2SC2879 high power linear RF power
transistors.
--Instant bandswitching, no tuning, no warm up --
just turn on and operate -- makes mobile QSOs safer.
--Very Compact -- Just 3 1/2 x 9 x 15 Inches -- fits
in nearly any mobile installation; weighs only 7 pounds.
--Extremely quiet -- quiet low speed, low volume fan
stays off and silent until temperature rises.
--Output Power -- 500 watts PEP, 400 Watts CW
Continuous Coverage -- 1.5 to 22 MHz 10/12 Meters with
easy to install optional kit.--Load Fault
Protection -- disables and bypasses amplifier if antenna
has excessively h high reflected power or if
bandswitching is set lower than exciter frequency --
virtually eliminates damage because of operating error;
has Load Fault LED indicator.
--Thermal Overload Protection -- disables and
bypasses amplifier if temperature is excessively high;
automatically resets when temp drop to safe level
Thermal Overload LED indicator.
--Excellent harmonic suppression -- multiple
section output network, push-pull output circuit has
excellent harmonic suppression.
--DC current meter lets you monitor collector
current.
--ON/OFF Switch -- bypasses amplifier for
"barefoot" operation without having to disconnect high
current power supply cables.
--Remote ON/OFF Control -- lets you remote
control ON/OFF function for out-of-the-way mounting of
amplifier.
--Exciter Drive -- less than 100 watts input
gives full output.
--Power Supply Requirements -- requires 14 VDC
at 80 amperes peak current for PA transistors and
separate line for 14 - 16 VDC at 4 amperes for control
and bias circuits. Made in USA.
ALS-500RC
REMOTE HEAD, 500M FOR SN# 13049 & ABOVE
Click Image For Larger
Picture
ALS-500RC
| The Ameritron ALS-500RC is a remote
control head for the Ameritron
ALS-500M amplifier with serial
number 13049 and above. (For ALS-500M
units with a serial number below 13049,
you can purchase the
ARF-500K remote kit to modify your
ALS-500M to use the ALS-500RC) The
ALS-500RC allows the amplifier to be
located away from the operating station
and still have access of the amplifiers
front panel controls. The ALS-500RC
operates the amplifiers power switch and
frequency select switch. The ALS-500RC
has LEDs to indicate power, transmit and
overload. It also has a current meter. |
|
|
